Browsed by
Category: Brooks? saddle

First ride on Mary, & adjusting a saddle

First ride on Mary, & adjusting a saddle

Yesterday I took Mary Poppins for her first spin around my neighborhood. She rides smoothly, with no noise from the rear coaster brake and only the occasional ‘tick’ sound that might be a moving part rubbing against a dent. That said, the coaster brake needs a lot of space to actually stop, and for quick stops (such as when my 6-year-old darts in front of me) I need to jump down off the saddle, which is less than ideal. I wonder if that’s typical of the Sturmey-Archer coaster brakes?

Mike took this photo of Audrey and I on our steel steeds just before we left. The riding boots, bought several seasons ago from J. Crew, work pretty well as a stylish alternative to a pant clip. I’m wearing a knee-length dress over harem pants – not that you can tell. Lesson learned: black outfits photograph poorly. Doesn’t Audrey look cute? Her bike was inherited from a neighbor, and it needs some TLC too – lots of rusty parts from being left outside, and the front tire is almost flat and may not be salvagable.

Anyway, before we could ride, I needed to adjust Mary’s saddle, since whoever had last rode her had either been a couple of inches taller than me or hadn’t cared whether they could touch the ground (I was on tiptoe). I took some photos during the process.

Before. The bolt in the centre of the shot is the one I needed to loosen. It was just a smidgen bigger than 1/2″, so I needed to use an adjustable hex wrench. It was, of course, seized. Luckily we had some WD-40 handy. I also needed it to work the saddle’s post loose. It wouldn’t go in further at all, so I pulled it out and sprayed a little lubricant into the frame.

This shot shows the top and inside of the seat post after removing the saddle. The top rim and inside are pretty rusty, I wonder if I should treat them with something? For now I just reassembled it…

…but not without taking some beauty shots of the saddle’s underside. That “MADE IN ENGLAND” stamp is the only identifying mark on it. Phillips catalogues from the period call these “spring mattress saddles”. A couple of things to note: at some point, someone needed to replace one of the screws holding the springs. Also, notice how skewed the springs themselves are! Holy cow! Somebody has ridden Mary hard (Am I allowed to write that on a family blog?). The springs can be removed and replaced, but I wonder if it’s worth the effort to find the springs for a saddle that’s damaged and not so comfy to sit on?

After reinstallation. It’s a good thing my legs aren’t any shorter! I also loosened the bolt in the middle of this shot to adjust the tilt of the seat. Getting it tight enough afterward to keep the seat from tilting while I rode was a bit challenging.

I did some hunting around on eBay, and it seems this unbranded vinyl saddle might not have been made by Brooks – there are almost identical blue-and-white saddles being sold that are labelled WRIGHTS that came off 1960s Hercules and Hawthorne roadsters (both also made by Raleigh), and a red-and-white vinyl saddle labelled LYCETT that came off a Raleigh.

So once again, I’d love some advice. Should I try to repair the seat? Should I replace the seat with a fancy new Brooks saddle? How should I handle the rust inside the frame? Is my coaster brake working as it should?